3M™ Dyneon™ Fluoroelastomer FC 2124

About
3M™ Dyneon™ Fluoroelastomer FC 2124 is a dipolymer made from hexafluoropropylene and vinylidene fluoride. FC 2124 has an incorporated bisphenol cure system Special Features Composition: dipolymer of vinylidene fluoride and hexafluoropropylene Proprietary incorporated cure technology Excellent hot tear properties for moulding articles with complex geometric profiles Process target: injection and transfer moulding, extrusion, bonding and calendering Faster curing version of 3M™ Dyneon™ Fluoroelastomer FC 2123 Clean running with excellent mould release Excellent compression set resistance for moulded goods Typical Applications 3M™ Dyneon™ Fluoroelastomer FC 2124 is suitable for the manufacture of moulded goods and products which require a good bonding between rubber and metal.&&

About

3M™ Dyneon™ Fluoroelastomer FC 2124 is a dipolymer made from hexafluoropropylene and vinylidene fluoride. FC 2124 has an incorporated bisphenol cure system Special Features Composition: dipolymer of vinylidene fluoride and hexafluoropropylene Proprietary incorporated cure technology Excellent hot tear properties for moulding articles with complex geometric profiles Process target: injection and transfer moulding, extrusion, bonding and calendering Faster curing version of 3M™ Dyneon™ Fluoroelastomer FC 2123 Clean running with excellent mould release Excellent compression set resistance for moulded goods Typical Applications 3M™ Dyneon™ Fluoroelastomer FC 2124 is suitable for the manufacture of moulded goods and products which require a good bonding between rubber and metal.&&

Product Description
Generic	氟橡胶
Material Status	Commercial: Active
Features	Good stripping performance,Agglomerability
Availabilitys	North America,Europe
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.80	g/cm³	Internal Method
Mooney viscosity
ML 1+10，121℃	23	MU	Internal Method
Fluorine content	66	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	70		ASTM D2240

elastic body	Nominal value	Unit	Test method
tensile strength	16.5	MPa	ASTM D412A
100% strain	3.60	MPa	ASTM D412A
Tensile strain
fracture	300	%	ASTM D412A
Compression deformation			ASTM D1414
200℃，70 hr	22	%	ASTM D1414
200℃，70 hr	20	%	ASTM D1414

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.