| About |
|---|
| 3M™ Dyneon™ Fluoroelastomer FC 2181Z is a dipolymer made from hexafluoropropylene and vinylidene fluoride. FC 2181Z has an incorporated bisphenol cure system. Special Features Composition: dipolymer of vinylidene fluoride and hexafluoropropylene Process targets: compression and transfer moulding and calendering Excellent demoulding of complex geometric profiles Medium viscosity Proprietary incorporated cure technology Typical Applications 3M™ Dyneon™ Fluoroelastomer FC 2181Z is typically used in extrusion applications, e.g. hoses and profiles.&& |
| Product Description | |
|---|---|
| Generic | 氟橡胶 |
| Material Status | Commercial: Active |
| Features | Good stripping performance |
| Availabilitys | North America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.80 | g/cm³ | Internal Method |
| Mooney viscosity | |||
| ML 1+10，121℃ | 44 | MU | Internal Method |
| Fluorine content | 66 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 72 | ASTM D2240 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 17.5 | MPa | ASTM D412A |
| 100% strain | 4.50 | MPa | ASTM D412A |
| Tensile strain | |||
| fracture | 240 | % | ASTM D412A |
| Compression deformation | ASTM D1414 | ||
| 200℃，70 hr | 18 | % | ASTM D1414 |
| 200℃，70 hr | 15 | % | ASTM D1414 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |