3M™ Dyneon™ Fluoroelastomer FPO 3631

About
Dyneon Fluoroelastomer FPO 3631 is a medium fluorine content, peroxide curable grade, which has been designed and tested for 2 component injection moulding and standard injection overmoulding processes with DSM Stanyl® Polyamide 46. The product provides excellent physical properties and very broad chemical resistance. Special Features Composition: terpolymer of vinylidene fluoride, hexafluoropropylene and tetrafluoroethylene plus cure site monomer Process target: two-component moulding or injection overmoulding Excellent flow Excellent physical properties Good low temperature properties High resistance against chemical fluids Excellent scorch safety Typical Applications Dyneon Fluoroelastomer FPO 3631 can be used for wide range of applications where the elastomer needs to be combined with a stiffening carrier material from DSM Stanyl® Polyamide 46 and also a broad chemical resistance is needed.&&

About

Dyneon Fluoroelastomer FPO 3631 is a medium fluorine content, peroxide curable grade, which has been designed and tested for 2 component injection moulding and standard injection overmoulding processes with DSM Stanyl® Polyamide 46. The product provides excellent physical properties and very broad chemical resistance. Special Features Composition: terpolymer of vinylidene fluoride, hexafluoropropylene and tetrafluoroethylene plus cure site monomer Process target: two-component moulding or injection overmoulding Excellent flow Excellent physical properties Good low temperature properties High resistance against chemical fluids Excellent scorch safety Typical Applications Dyneon Fluoroelastomer FPO 3631 can be used for wide range of applications where the elastomer needs to be combined with a stiffening carrier material from DSM Stanyl® Polyamide 46 and also a broad chemical resistance is needed.&&

Product Description
Generic	氟橡胶
Material Status	Commercial: Active
Features	High liquidity,Antifreeze,Solvent resistance,Terpolymer
Availabilitys	North America,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.81	g/cm³	Internal Method
Mooney viscosity
ML 1+10，121℃	37	MU	Internal Method
Fluorine content	67	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	75		ASTM D2240

elastic body	Nominal value	Unit	Test method
tensile strength	15.2	MPa	DIN 53504
100% strain	9.60	MPa	DIN 53504
Tensile strain
fracture	200	%	DIN 53504
Compression deformation
200℃，70 hr	30	%	ASTM D395B

THERMAL	Nominal value	Unit	Test method
Glass transition temperature	-19.0	℃

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.