3M™ Dyneon™ Fluoroelastomer MIP 8740

About
3M™ Dyneon™ Fluoroelastomer MIP 8740 is a terpolymer made from hexafluoropropylene, vinylidene fluoride and tetrafluoroethylene. MIP 8740 has an incorporated bisphenol cure system. Special Features Composition: terpolymer of vinylidene fluoride, hexafluoropropylene and tetrafluoroethylene Process targets: injection, transfer and compression moulding Improved cure technology over 3M™ Dyneon™ Fluoroelastomer 2000 series resulting in more consistent part size from successive moulding cycles Improved scorch resistance at high moulding temperatures Low compression set Excellent physical properties Excellent flow Typical Applications Due to the proprietary MIP technology 3M™ Dyneon™ Fluoroelastomer MIP 8740 can be used in for the production of O-rings in injection as well as in compression and transfer moulding.&&

About

3M™ Dyneon™ Fluoroelastomer MIP 8740 is a terpolymer made from hexafluoropropylene, vinylidene fluoride and tetrafluoroethylene. MIP 8740 has an incorporated bisphenol cure system. Special Features Composition: terpolymer of vinylidene fluoride, hexafluoropropylene and tetrafluoroethylene Process targets: injection, transfer and compression moulding Improved cure technology over 3M™ Dyneon™ Fluoroelastomer 2000 series resulting in more consistent part size from successive moulding cycles Improved scorch resistance at high moulding temperatures Low compression set Excellent physical properties Excellent flow Typical Applications Due to the proprietary MIP technology 3M™ Dyneon™ Fluoroelastomer MIP 8740 can be used in for the production of O-rings in injection as well as in compression and transfer moulding.&&

Product Description
Generic	氟橡胶
Material Status	Commercial: Active
Features	Good Dimensional Stability,Good liquidity,Terpolymer
Availabilitys	North America,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.86	g/cm³	Internal Method
Mooney viscosity
ML 1+10，121℃	41	MU	Internal Method
Fluorine content	69	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	82		ASTM D2240

elastic body	Nominal value	Unit	Test method
tensile strength	15.1	MPa	ASTM D412A
100% strain	6.30	MPa	ASTM D412A
Tensile strain
fracture	210	%	ASTM D412A
Compression deformation
200℃，70 hr	28	%	ASTM D1414

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.