3M™ Dyneon™ Fluoroplastic PFA 6515NZ

About
3M™ Dyneon™ Fluoroplastic PFA 6515NZ, a fully fluorinated copolymer made from tetrafluoroethylene and perfluorvinylether, is characterised by its excellent temperature resistance, optimal chemical and weathering resistance and very good dielectric capabilities. Special Features Wide service temperature range Extremely high weathering resistance and UV stability High limiting oxygen index: Does not support combustion Good non-stick characteristics Improved adhesion to metal Excellent, almost universal resistance to solvents and chemicals Excellent electrical insulation properties, e.g.: dielectric breakdown strength, dielectric constant Good low-friction properties&&

About

3M™ Dyneon™ Fluoroplastic PFA 6515NZ, a fully fluorinated copolymer made from tetrafluoroethylene and perfluorvinylether, is characterised by its excellent temperature resistance, optimal chemical and weathering resistance and very good dielectric capabilities. Special Features Wide service temperature range Extremely high weathering resistance and UV stability High limiting oxygen index: Does not support combustion Good non-stick characteristics Improved adhesion to metal Excellent, almost universal resistance to solvents and chemicals Excellent electrical insulation properties, e.g.: dielectric breakdown strength, dielectric constant Good low-friction properties&&

Product Description
Generic	PFA
Material Status	Commercial: Active
Features	Weather resistance is good,No viscosity,Good Electrical Properties,Low Viscosity,Low coefficient of friction,Good bond,Copolymer,Solvent resistance,Insulation
Availabilitys	North America,Europe
Process Methods	Extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	2.15	g/cm³	ISO 12086
Melt Flow Rate
372℃，5.0kg	15	g/10min	ISO 1133

THERMAL	Nominal value	Unit	Test method
Melting temperature	310	℃	ISO 12086

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
Extreme oxygen index	> 95	%	ASTM D2863

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	60		ASTM D2240，ISO 868
tensile strength
Fracture, 23 ℃	26.0	MPa	ISO 527-1-2
Tensile strain
Fracture, 23 ℃	420	%	ISO 527-1
Bending modulus	620	MPa	ASTM D790

Process Conditions
injection	Nominal value	Unit	Test method
Extrusion	Nominal value	Unit	Test method
Processing (melt) temperature	250 to 400	°C
Melt temperature	< 400	°C

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.