| About |
|---|
| Basic type PA 6 for injection moulding, modified for general use, with excellent manufacturing properties. Use: automotive, engineering, electrical and consumer-goods industry – electrical tools, fasteners, clamps, hobby tools, toys. Delivered in the natural mode and in the full RAL colour scale.&& |
| Product Description | |
|---|---|
| Generic | PTFE |
| Material Status | Commercial: Active |
| Availabilitys | Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 2.24 | g/cm³ | ASTM D4745-06 |
| Apparent density | 0.74 | g/cm³ | ASTM D4894 |
| Shrinkage rate | |||
| MD | 2.0 | % | ASTM D4894-07 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 66 | DIN 53505 | |
| tensile strength | 24.0 | MPa | ASTM D4745-06 |
| Tensile strain | |||
| fracture | 300 | % | ASTM D4745-06 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |