3M™ Dyneon™ TFM™ Modified PTFE TFMR 1602

About
Modified suspension PTFE especially designed for ram extrusion of thick walled pipes and rods. Special Features Meets ASTM D4894 – Type VI classification Produced by suspension polymerisation Tailor made for ram extrusion Excellent free-flowing and feeding properties Good mouldability Reduced deformation under load (cold flow) Higher transparency Smoother surfaces on machined parts Less porosity and reduced permeability Better compression stress relaxation Improved weldability Chemical inertness Low friction behaviour Good flame retardance Exceptional temperature resistance&&

About

Modified suspension PTFE especially designed for ram extrusion of thick walled pipes and rods. Special Features Meets ASTM D4894 – Type VI classification Produced by suspension polymerisation Tailor made for ram extrusion Excellent free-flowing and feeding properties Good mouldability Reduced deformation under load (cold flow) Higher transparency Smoother surfaces on machined parts Less porosity and reduced permeability Better compression stress relaxation Improved weldability Chemical inertness Low friction behaviour Good flame retardance Exceptional temperature resistance&&

Product Description
Generic	PTFE
Material Status	Commercial: Active
Features	Excellent Processability,Good Clarity,Good liquidity,Low coefficient of friction,Flame Characteristics,Welding
Availabilitys	North America,Europe
Process Methods	Plunger extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	2.16	g/cm³	ISO 12086
Apparent density	0.80	g/cm³	ISO 60
Shrinkage rate	11	%	Internal Method
Average particle size	800	µm	ISO 13320

film	Nominal value	Unit	Test method
tensile strength
500 µm	35.0	MPa	ISO 12086
Tensile strain
Fracture, 500 µ m	500	%	ISO 12086

THERMAL	Nominal value	Unit	Test method
Thermal conductivity coefficient	0.22	W/m/K	DIN 52612

Electrical performance	Nominal value	Unit	Test method
Surface resistivity	1.0E+17	ohms	IEC 60093
Volume resistivity	1.0E+18	ohms·cm	IEC 60093

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	53		ISO 868
Load deformation			ASTM D621
23℃，15 MPa	14.0	%	ASTM D621
23℃，15 MPa	6.00	%	ASTM D621

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.