| About |
|---|
| Product Description | |
|---|---|
| Supplier | Shinkong |
| Generic | PC+PBT |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,High impact resistance,Good liquidity,Solvent resistance |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Water absorption rate | 0.14 | % | ASTM D570 |
| Density | 1.20 | ASTM D792 | |
| Melt Flow Rate | |||
| 265℃，2.16kg | 14 | g/10min | ASTM D1238 |
| Shrinkage rate | |||
| MD | 0.4-0.6 | % | ASTM D955 |
| TD | 0.5-0.7 | % | ASTM D955 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 74 | ℃ | ASTM D648 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | HB | UL 94 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 38 | KV/mm | ASTM D149 |
| Process Conditions | |||
|---|---|---|---|
| Processing temperature | Nominal value | Unit | Test method |
| drying temperature | 140 | ℃ | |
| Drying time | 2 | hr | |
| drying temperature | 120 | ℃ | |
| Drying time | 4 | hr | |
| drying temperature | 100 | ℃ | |
| Drying time | 6 | hr | |
| Temperature at the rear end of the barrel | 240-230 | ℃ | |
| Temperature at the middle end of the barrel | 245-235 | ℃ | |
| Front end temperature of material barrel | 250-240 | ℃ | |
| Nozzle temperature | 255-245 | ℃ | |
| Mold temperature | 60-80 | ℃ | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |