| About |
|---|
| LubriOne™ Lubricated and Wear-Resistant Compounds have been specifically formulated to be self-lubricating materials, offering low coefficient of friction and improved wear resistance properties. LubriOne compounds have been demonstrated to reduce friction, noise, vibration, heat buildup and improve product durability. |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | PA66 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Weather resistance is good,Lubricating,Good wear resistance |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.47 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 0.20 to 0.40 | % | |
| TD | 1.0 to 2.0 | % | |
| Water absorption rate | |||
| 24hr | 0.60 | % | ASTM D570 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile strength (yield) | 156 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 5.0 | % | ASTM D638 |
| Bending modulus | 9110 | MPa | ASTM D790 |
| bending strength | 232 | MPa | ASTM D790 |
| friction coefficient | |||
| dynamic | 0.49 | ASTM D3702 | |
| static state | 0.51 | ASTM D3702 | |
| Steel – Dynamic | 0.19 | ASTM D1894 | |
| Steel – Static | 0.19 | ASTM D1894 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23 ° C, 3.2mm, injection molding | 75 | J/m | ASTM D256-A |
| Notched impact strength of cantilever beam | |||
| 23℃，3.2 mm | 910 | J/m | ASTM D256 |
| Process Conditions | |||
|---|---|---|---|
| Injection | Nominal value | Unit | Test method |
| drying temperature | 82 | °C | |
| Drying time | 4.0 to 5.0 | hr | |
| Recommended maximum moisture content | 0.20 | % | |
| Temperature at the rear of the barrel | 246 to 293 | °C | |
| Temperature in the middle of the barrel | 268 to 293 | °C | |
| Front temperature of material barrel | 260 to 299 | °C | |
| Nozzle temperature | 260 to 293 | °C | |
| Mold temperature | 38 to 93 | °C | |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |