InnoPlus LD2420F

About
InnoPlus LD2420F is produced by high pressure tubular process, a technology licensed by LyondellBasell. This grade offers excellent processability for increased extruder outputs, good balance of mechanical and optical properties, exceptional clarity and gloss. Typical Applications : InnoPlus LD2420F is recommended for producing the heavy duty films, agricultural films, shrink films, tubes and small extrusion blow molding containers. Additives : No additives.&&

About

InnoPlus LD2420F is produced by high pressure tubular process, a technology licensed by LyondellBasell. This grade offers excellent processability for increased extruder outputs, good balance of mechanical and optical properties, exceptional clarity and gloss. Typical Applications : InnoPlus LD2420F is recommended for producing the heavy duty films, agricultural films, shrink films, tubes and small extrusion blow molding containers. Additives : No additives.&&

Product Description
Generic	LDPE
Material Status	Commercial: Active
Features	Excellent Processability,Good Clarity,Good surface appearance,Low density
Availabilitys	Asia Pacific

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.922	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	0.75	g/10min	ISO 1133

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	260	MPa	ISO 527-2

film	Nominal value	Unit	Test method
film thickness
test	50	µm
tensile strength			ISO 527-3
yield	11.0	MPa	ISO 527-2
MD, fracture, 50 µ m, blow molded film	25.0	MPa	ISO 527-3
TD, fracture, 50 µ m, blow molded film	23.0	MPa	ISO 527-3
Tensile strain			ISO 527-3
MD, fracture, 50 µ m, blow molded film	400	%	ISO 527-3
TD, fracture, 50 µ m, blow molded film	700	%	ISO 527-3
Drop hammer impact
50 µ m, blow molded film	170	g	ASTM D1709

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	94.0	℃	ASTM D1525
Melting temperature	112	℃	ISO 11357-3

optical performance	Nominal value	Unit	Test method
gloss
20 °, 50 µ m, blow molded film	60		ASTM D2457
Haze
50 µ m, blow molded film	6.0	%	ASTM D1003

Process Conditions
Extrusion	Nominal value	Unit	Test method
Melt temperature	170 to 220	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.