| About |
|---|
| OREVAC® 18345 RNP is a maleic anhydride modified linear low-density polyethylene available in black powder form. Applications OREVAC® 18345 RNP has been designed to be used as topcoat-layer coatings (epoxy primer/polyethylene) for external pipe protection, especially for coating field joint applications.&& |
| Product Description | |
|---|---|
| Supplier | Arkema |
| Generic | EPE |
| Material Status | Commercial: Active |
| Features | Good bond,Heat Resistance, Good |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | sintering |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.930 | g/cm³ | ISO 1183 , ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 8.0 | g/10min | ASTM D1238，ISO 1133 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 88.0 | ℃ | ISO 306/A , ASTM D1525 2 |
| Melting temperature | 121 | ℃ | ISO 11357-3 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 49 | ASTM D2240 , ISO 868 | |
| tensile strength | |||
| Fracture, molded | 13.0 | MPa | ASTM D638 , ISO 527-2 |
| Tensile strain | |||
| Fracture, molded | 700 | % | ASTM D638 , ISO 527-2 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |