ZEONEX® RS420-LDS

About
LDS compatible, ultra-low dielectric loss and dielectric constant for antenna and MID Features Very low loss tangent Low moisture absorption LDS compatible Good moldability Uses LDS antenna MID RF connector&&

Product Description
Supplier	Zeon
Generic	COP
Material Status	Commercial: Negative
Features	Excellent Processability,Low moisture absorption
Availabilitys	North America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.01	g/cm³	ASTM D792
Melt Flow Rate
280℃，2.16kg	7.0	g/10min	JIS K6719
Water absorption rate
balance	< 0.010	%	ASTM D570

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	2100	MPa	ISO 527-2
tensile strength	45.0	MPa	ISO 527-2
Tensile strain
fracture	25	%	ISO 527-2
Bending modulus	2500	MPa	ISO 178

THERMAL	Nominal value	Unit	Test method
Glass transition temperature	134	℃	JIS K7121
Linear coefficient of thermal expansion
MD	7.0E-5	1/℃	ASTM E831

Electrical performance	Nominal value	Test method
Dielectric constant
1.00 GHz	2.20	ASTM D150
Dissipation factor
1 GHz	< 1.0E-3	ASTM D150

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.