| About |
|---|
| 玻纤增强，阻燃 |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | PA66 |
| Material Status | Commercial: Active |
| Features | High impact resistance,Good Electrical Properties,Flame Characteristics,Good wear resistance,Solvent resistance,Heat Stabilized |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.62 | g/cm³ | ASTM D792 |
| Shrinkage rate | 0.3-0.6 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 160 | MPa | ASTM D638 |
| bending strength | 240 | MPa | ASTM D790 |
| Bending modulus | 10500 | MPa | ASTM D790 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa | 240 | ℃ | ASTM D648 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | 1.00E+14 | ohms | ASTM D257 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Combustion level 1.6mm | V-0 | Internal |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 3.2mm | 85 | J/m | ASTM D256 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Barrel temperature | 260-280 | °C | |
| Barrel temperature | 260-280 | °C | |
| Mold temperature | 65-85 | °C | |
| Drying temperature | 80-90 | °C | |
| Drying time | 4-6 | hr | |
| Injection pressure | 中高（MED-HIGH） | ||
| Hold pressure | 中高（MED-HIGH） | ||
| Screw speed | 中等（MODERATE） | ||
| Back pressure | 低（LOW） | ||
| Mold temperature | 65-85 | °C | |
| Drying temperature | 80-90 | °C | |
| Drying time | 4-6 | hr | |
| Injection pressure | 中高（MED-HIGH） | ||
| Hold pressure | 中高（MED-HIGH） | ||
| Screw speed | 中等（MODERATE） | ||
| Back pressure | 低（LOW） | ||
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |