| About |
|---|
| NYCOA 2245 is a highly flexible Nylon copolymer TPE developed for both injection molding and extrusion applications. The chemical composition of NYCOA 2245 delivers improved impact performance at ambient or low temperatures, and increased flexibility to meet higher impact performance. The high thermal and chemical resistance, inherent to Nylon 6, is retained. The chemistry of the resin promotes good adhesion to olefins and other materials, without the problem of migration associated with the use of plasticizers. In addition, its high melt viscosity and melt strength provides outstanding processability for tubing, profile, sheet, and monofilament. This product is available with custom additive packages: heat stabilizer, UV stabilizer, flame retardant and custom colors.&& |
| Product Description | |
|---|---|
| Generic | PA+TPE |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Excellent Processability,Good flexibility,High impact resistance,High Viscosity,High Heat Resistance,Good bond,Good melt strength,Solvent resistance,low-temperature impact resistance |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.01 | g/cm³ | ASTM D792 |
| Shrinkage rate | ASTM D955 | ||
| MD | 1.0 | % | ASTM D955 |
| TD | 1.2 | % | ASTM D955 |
| Water absorption rate | |||
| 24hr | 1.1 | % | ASTM D570 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 6.4mm | 750 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 205 | ℃ | DSC |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 63 | ASTM D2240 | |
| tensile strength | 42.1 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 400 | % | ASTM D638 |
| Bending modulus | 448 | MPa | ASTM D790 |
| bending strength | 20.0 | MPa | ASTM D790 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |