| About |
|---|
| AGILITY EC 7000 Performance LDPE is a next generation low density polyethylene resin for high speed extrusion coating Main Characteristics: Recommended for extrusion at high and low temperatures Robustness in melt drawing Performance as sealant polymer Complies with: Europe Commission Regulation (EU) No 10/2011 U.S. FDA 21 CFR 177.1520 ( c )2.1 Consult the regulations for complete details.&& |
| Product Description | |
|---|---|
| Supplier | DOW |
| Generic | LDPE |
| Material Status | Commercial: Active |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.919 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 3.9 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 10.0 | MPa | ISO 527-2 |
| Tensile strain | |||
| fracture | 540 | % | ISO 527-2 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | 110 | ℃ | Internal Method |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Shrinkage – 25 g/m2 @ 100 mpm 2 (320癈) | 148.0 | mm | |
| Pulldown – from 15 g/m2 @ 100 m/min 2 (320癈) | 500 | m/min | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Coating onto paper substrate and/or coating web at 250 mm air gap and -15mm nip off-set. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |