| About |
|---|
| Monprene OM-10160 is a high performance thermoplastic elastomer designed for overmolding applications like grips and anti-skid parts for consumer products. Monprene OM-10160 is a medium hardness, low density, opaque grade that exhibits excellent adhesion to nylon.&& |
| Product Description | |
|---|---|
| Supplier | Teknor Apex |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good flexibility,Good surface appearance,Halogen free,Good bond,Elastic,Low density,Good tear strength,Good wear resistance,Solvent resistance,Good coloring,Agglomerability |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.918 | g/cm³ | ASTM D792 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 15 | g/10min | ASTM D1238 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 5.52 | MPa | ASTM D412 |
| Tensile strain | |||
| fracture | 600 | % | ASTM D412 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | ASTM D2240 | ||
| Shaw’s A | 62 | ASTM D2240 | |
| Shore A, 5 seconds | 60 | ASTM D2240 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Adhesion to Nylon |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 66 | °C | |
| Drying time | 2.0 to 4.0 | hr | |
| Barrel rear temperature | 204 to 232 | °C | |
| Barrel middle temperature | 210 to 232 | °C | |
| Barrel front temperature | 216 to 238 | °C | |
| Nozzle temperature | 221 to 243 | °C | |
| Processing (melt) temperature | 221 to 243 | °C | |
| Mold temperature | 24 to 60 | °C | |
| Injection pressure | 1.38 to 6.89 | MPa | |
| Injection speed | Fast | ||
| Back pressure | 0.172 to 0.862 | MPa | |
| Screw speed | 50 to 120 | rpm | |
| Cushion | 3.81 to 25.4 | mm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |