| About |
|---|
| SABIC® HDPE B4520 is developed for blow moulding packaging up to 20 l, combining medium stiffness with a superior ESCR. This grade is suitable for packaging aggressive detergents and technical articles such as, spare fuel tanks, air- and cable ducts. The product mentioned herein is in particular not tested and therefore not validated for use in pharmaceutical/medical applications.&& |
| Product Description | |
|---|---|
| Supplier | SABIC |
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | High ESCR,Good Rigidity |
| Availabilitys | Latin America,North America |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.945 | g/cm³ | ISO 1183 |
| Melt Flow Rate | ISO 1133 | ||
| 190℃，2.16kg | 0.16 | g/10min | ISO 1133 |
| 190℃，21.6kg | 20 | g/10min | ISO 1133 |
| 190℃，5.0kg | 0.89 | g/10min | ISO 1133 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 75 ℃, 1.00 mm, detergent detergents | 40.0 | hr | Internal Method |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Izod notched Impact | ISO 180/1A | ||
| -30℃ | 5.0 | kJ/m² | ISO 180-1A |
| 23℃ | 12 | kJ/m² | ISO 180-1A |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature HDT | |||
| 0.45 MPa, unannealed | 73.0 | ℃ | ISO 75-2/B |
| Vicat Softening Temperature | 126 | ℃ | ISO 306/A |
| Melting temperature | |||
| DSC | 133 | ℃ | DIN 53765 |
| Enthalpy Change | 181 | J/g | DIN 53765 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore D, Compression Molding | 59 | ISO 868 | |
| Tensile Modulus | |||
| 2 mm, compression molding | 800 | MPa | ISO 527-2/1BA/50 |
| Tensile Strength | ISO 527-2/1BA/50 | ||
| Yield yld, 2 mm, compression molding | 22.0 | MPa | ISO 527-2/1BA/50 |
| Fracture yld, 2 mm, compression molding | 31.0 | MPa | ISO 527-2/1BA/50 |
| Tensile Strain | |||
| Break, 2 mm, compression molding | > 1000 | % | ISO 527-2/1BA/50 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 3 MPa |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |