| About |
|---|
| Lucky Enpla LPC1000 is a Polycarbonate (PC) product. It can be processed by injection molding and is available in Asia Pacific, Europe, or North America. Typical application: Electrical/Electronic Applications.&& |
| Product Description | |
|---|---|
| Supplier | Lucky Enpla |
| Generic | Polycarbonate |
| Material Status | Commercial: Active |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.20 | g/cm³ | ASTM D792 |
| Shrinkage rate | |||
| MD | 0.50 to 0.80 | % | ASTM D955 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 61.8 | MPa | ASTM D638 |
| Bending modulus | 2260 | MPa | ASTM D790 |
| bending strength | 89.2 | MPa | ASTM D790 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Notched impact strength of cantilever beam | |||
| 3.2 mm | 740 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 132 | ℃ | ASTM D648 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature | 70 to 90 | °C | |
| Drying time | 2.0 to 3.0 | hr | |
| Barrel rear temperature | 270 to 280 | °C | |
| Barrel middle temperature | 280 to 290 | °C | |
| Barrel front temperature | 290 to 300 | °C | |
| Nozzle temperature | 285 to 300 | °C | |
| Mold temperature | 60 to 80 | °C | |
| Back pressure | 1.96 to 3.92 | MPa | |
| Screw speed | 60 to 80 | rpm | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 1.2 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |