| About |
|---|
| Asahi Kasei Tuftec™ H1041 is good for easy peel film application. It can be also used as a modifier for a variety of plastics with its superior balance of mechanical property and melt flowability. Olefinic and styrenic resins modifier, for high impact strength. Compatibilizer. Adhesives and sealants component. Base polymer of SEBS molding compounds.&& |
| Product Description | |
|---|---|
| Supplier | Asahi Kasei |
| Generic | SEBS |
| Material Status | Commercial: Active |
| Features | High impact resistance,Good liquidity |
| Availabilitys | Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.910 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 5.0 | g/10min | ISO 1133 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s A | 84 | ISO 7619 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 21.6 | MPa | ISO 37 |
| 300% strain | 3.40 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 650 | % | ISO 37 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Styrene/Rubber ratio | 30/70 | Internal Method |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type 1A, 20 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |