| About |
|---|
| Glasrod SG-200 is a solid rod and bar fiberglass-reinforced thermoset polyester shape that exhibits properties desirable for a wide range of structural and electrical applications. Highest temperature rated for 210°C/210°C service. Excellent thermal endurance. Ideal replacement for silicone rod. Available in Rectangular, Square, “A” and Dogbone shapes.&& |
| Product Description | |
|---|---|
| Generic | 热固性聚酯 |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Good Dimensional Stability,Low or no water absorption,High Heat Resistance,Solvent resistance |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.85 | g/cm³ | ASTM D792 |
| Water absorption rate | |||
| 24hr | 0.15 | % | ASTM D570 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 1.38E+6 | MPa | ASTM D638 |
| tensile strength | |||
| yield | 483 | MPa | ASTM D638 |
| Bending modulus | 20700 | MPa | ASTM D790 |
| bending strength | |||
| yield | 552 | MPa | ASTM D790 |
| shear strength | 20.7 | MPa | ASTM D732 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | 2100 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Linear coefficient of thermal expansion | |||
| MD | 7.0E-6 | 1/℃ | ASTM D696 |
| Thermal conductivity coefficient | 0.29 | W/m/K | ASTM C177 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | |||
| 25.4 mm in oil | 2.8 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 60 Hz | 5.00 | ASTM D150 | |
| Arc resistance | 150 | sec | ASTM D495 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |