| About |
|---|
| Description LUTENE-H ME1000 is mainly intended for injection molding and compression molding of bottle caps and closures. It has an excellent environmental stress crack resistance and organoleptic property. Applications Cap & Closure for beverage bottles of sparking water Hot-fill and Carbonated soft drinks&& |
| Product Description | |
|---|---|
| Supplier | LG Chemical |
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Good sensory characteristics.,High ESCR |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.852 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.90 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 78 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 123 | ℃ | ASTM D1525 |
| Melting temperature | 131 | ℃ |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D, molded | 64 | ASTM D2240 | |
| tensile strength | |||
| Yield, molding | 25.5 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, molded | > 700 | % | ASTM D638 |
| Bending modulus | |||
| 1% cut, molded | 785 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Processing (melt) temperature | < 250 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |