| About |
|---|
| GLS 422-126 is designed to pass several fatty food extraction conditions identified in EU Directive 10/2011 and may be appropriate where FDA and EU 10/2011 compliances are required. GLS 422-126 will also overmold and co-extrude to polypropylene.&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | TPE |
| Material Status | Commercial: Active |
| Features | Food contact compliance |
| Availabilitys | Europe |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| MECHANICAL | Nominal value | Unit | Test method |
| Shore hardness | |||
| Shore A, 3 seconds | 50 | DIN 53505 | |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | DIN 53504 | ||
| 100% strain, 23 ℃ | 1.50 | MPa | DIN 53504 |
| 300% Strain, 73°F | 2.50 | MPa | DIN 53504 |
| MD, fracture, 23 ℃ | 6.00 | MPa | DIN 53504 |
| TD, fracture, 23 ℃ | 12.9 | MPa | DIN 53504 |
| Tensile strain | DIN 53504 | ||
| TD, fracture, 23 ℃ | 650 | % | DIN 53504 |
| Flow rate, fracture, 23 ℃ | 450 | % | DIN 53504 |
| PHYSICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Density | 0.898 | g/cm³ | ISO 1183 |
| Apparent viscosity of melt | |||
| 200℃，11200 sec^-1 | 40.4 | Pa·s | Internal Method |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Proposed maximum recycled material ratio | 20 | % | |
| Barrel rear temperature | 193 to 204 | °C | |
| Barrel middle temperature | 199 to 216 | °C | |
| Barrel front temperature | 204 to 227 | °C | |
| Nozzle temperature | 210 to 238 | °C | |
| Processing (melt) temperature | 204 to 227 | °C | |
| Mold temperature | 13 to 32 | °C | |
| Back pressure | 0.00 to 0.552 | MPa | |
| Screw speed | 50 to 100 | rpm | |
| Melt temperature | 204 to 227 | °C | |
| Nozzle temperature | 216 to 238 | °C | |
| Notes |
|---|
| 1. Product rating may be influenced by end product design and/or conditions of use. Please contact GLS Thermoplastic Elastomers for information addressing EU (EU, 10/2011) and FDA (21 CFR 177.1210) compliance. |
| 2. Typical properties: these are not to be construed as specifications. |
| 3. Die C |
| 4. 2 hr |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |