| About |
|---|
| Talc filled (16%), high impact PP Compound. INSPIRE* TF1305 SC has been developed for covered interior automotive applications. Also designed for self-coloration (SC) in combination with PROMATCH* combi-masterbatches for uncovered applications with high demanding aesthetics, scratch resistance, and UV light stabilisation. It is especially suitable for car interior applications requiring ductility, because of its high impact resistance, even at low temperature. Applications: Instrument panel retainer Instrument panel trim Mid console Door panels Door pockets Interior trim Trunk trim&& |
| Product Description | |
|---|---|
| Supplier | Trinseo |
| Generic | Polyolefin Elastomer |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Good surface appearance,High impact resistance,Ductility,low-temperature impact resistance,High scratch resistance |
| Availabilitys | Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.02 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 230℃，2.16kg | 9.5 | g/10min | ISO 1133 |
| Shrinkage rate | 0.90 to 1.2 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 1950 | MPa | ISO 527-1-2 |
| tensile strength | |||
| yield | 20.0 | MPa | ISO 527-2/50 |
| Tensile strain | |||
| fracture | 70 | % | ISO 527-2/50 |
| Bending modulus | 1850 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | ISO 180/1A | ||
| 0℃ | 8.0 | kJ/m² | ISO 180-1A |
| 23℃ | 15 | kJ/m² | ISO 180-1A |
| Multi axis instrument impact energy | |||
| 23℃，Energy to Break，Ductile Failure | 70.0 | J | ISO 6603-2 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 58.0 | ℃ | ISO 75-2/A |
| 0.45 MPa, unannealed | 110 | ℃ | ISO 75-2/B |
| Vicat Softening Temp | 135 | ℃ | ISO 306/A120 |
| Linear coefficient of thermal expansion | |||
| MD | 8.5E-5 | 1/℃ | ASTM D696 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 0,079 in/min |
| 3. 3 point load |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |