SABIC® PPcompound 8650U

About
SABIC® PPcompound 8650U a development grade, elastomer-modified mineral filled Polypropylene for automotive exterior applications. This material combines excellent stiffness and high impact with low density. The combination makes the material very suitable for thin wall bumper applications. This grade is UV stabilized and can be used for unpainted applications. This grade will also be available in an open concept (8650 MB1 & 8650 MB2) and for painted applications (8650). SABIC® PPcompound 8650U is a designated automotive grade.&&

About

SABIC® PPcompound 8650U a development grade, elastomer-modified mineral filled Polypropylene for automotive exterior applications. This material combines excellent stiffness and high impact with low density. The combination makes the material very suitable for thin wall bumper applications. This grade is UV stabilized and can be used for unpainted applications. This grade will also be available in an open concept (8650 MB1 & 8650 MB2) and for painted applications (8650). SABIC® PPcompound 8650U is a designated automotive grade.&&

Product Description
Supplier	SABIC
Generic	PP not specified
Material Status	Commercial: Active
Features	Good Rigidity,Weather resistance is good,High impact resistance,Low density
Availabilitys	Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.970	g/cm³	ISO 1183
Melt Flow Rate
230℃，2.16kg	25	g/10min	ISO 1133
Shrinkage rate
3.2 mm，24 hrs	0.70 to 0.80	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus
injection molding	1500	MPa	ISO 527-2/1B
tensile strength			ISO 527-2/1A
Yield, injection molding	18.0	MPa	ISO 527-2/1A
Fracture, injection molding	15.0	MPa	ISO 527-2/1A
Tensile strain
Fracture, injection molding	60	%	ISO 527-2/1A
Bending modulus
injection molding	1550	MPa	ASTM D790

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch			ISO 180/4A
-20 ℃, injection molding	8.0	kJ/m²	ISO 180-4A
0 ℃, injection molding	15	kJ/m²	ISO 180-4A
23 ℃, injection molding	无断裂		ISO 180/4A

THERMAL	Nominal value	Unit	Test method
Linear coefficient of thermal expansion
MD：-30~100℃	7.0E-5	1/℃	ASTM D696

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.