3M™ Dyneon™ Fluoroplastic FEP 6322HTZ

About
3M™ Dyneon™ Fluoroplastic FEP 6322HTZ is a fully fluorinated copolymer comprising tetrafluoroethylene and hexafluoropropylene and is belonging to the product class FEP. It was designed primarily for high speed extrusion for wire insulation. Special Features Excellent dielectric properties High thermal stability High extrusion speed Wide processing window Complies with VDE 0207 Extremely low flammability (high LOI) Excellent low smoke properties Low coefficient of friction Very high weathering and UV stability&&

About

3M™ Dyneon™ Fluoroplastic FEP 6322HTZ is a fully fluorinated copolymer comprising tetrafluoroethylene and hexafluoropropylene and is belonging to the product class FEP. It was designed primarily for high speed extrusion for wire insulation. Special Features Excellent dielectric properties High thermal stability High extrusion speed Wide processing window Complies with VDE 0207 Extremely low flammability (high LOI) Excellent low smoke properties Low coefficient of friction Very high weathering and UV stability&&

Product Description
Generic	FEP
Material Status	Commercial: Active
Features	Weather resistance is good,Excellent Processability,Low smoke,High liquidity,Low coefficient of friction,Copolymer,Heat Stabilized
Availabilitys	North America,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	2.15	g/cm³	ISO 12086
Melt Flow Rate
372℃，5.0kg	22	g/10min	ISO 1133

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	670	MPa	ISO 527-2
tensile strength
Fracture, 23 ℃	20.0	MPa	ISO 527-2
Tensile strain
Fracture, 23 ℃	300	%	ISO 527-2

THERMAL	Nominal value	Unit	Test method
Melting temperature	255	℃	ISO 12086

Electrical performance	Nominal value	Unit	Test method
Dielectric strength
0.25 mm	65	kV/mm	ASTM D149
Dielectric constant			ASTM D150
23 ℃，1 MHz	< 2.15		ASTM D150
23 ℃，9.40 GHz	2.06		ASTM D150
Dissipation factor			ASTM D150
1 MHz	< 9.0E-4		ASTM D150
9.4 GHz	4.0E-4		ASTM D150

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
Extreme oxygen index	> 95	%	ASTM D2863

Process Conditions
Extrusion	Nominal value	Unit	Test method
Barrel 1 zone temperature	285	°C
Barrel 2 zone temperature	305	°C
Barrel 3 zone temperature	320	°C
Barrel 4 zone temperature	330	°C
Nozzle temperature	340	°C

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.