| About |
|---|
| R902U is a linear low-density polyethylene resin for rotational molding applications. This grade is available in pellet form. This grade is designed to be processed in conventional rotational molding equipment.&& |
| Product Description | |
|---|---|
| Supplier | HANWHA |
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,Good surface appearance,High impact resistance,Good liquidity,Low density,Solvent resistance |
| Availabilitys | North America,Asia Pacific |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.933 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 6.0 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| F50 | 1000 | hr | ASTM D1693 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 540 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | -80.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 112 | ℃ | ASTM D1525 1 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 62 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| yield | 15.7 | MPa | |
| fracture | 19.6 | MPa | |
| Tensile strain | |||
| fracture | 1100 | % | ASTM D638 |
| Bending modulus | |||
| 23℃ | 550 | MPa | ASTM D747 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |