Rulon® 123 - SOLIAO

About
Rulon® 123 is a glossy black non-abrasive compound for softer mating surfaces, such as stainless steel. This material has excellent chemical resistance and is FDA and USDA compliant. It is less expensive than Rulon J, but is slightly less flexible and higher in wear. It has a high resistance to deformation, low coefficient of friction and good thermal and electrostatic dissipation. This material has a maximum operating temperature of 550°F (300°C). Rulon 123 releases black wear debris over time and should not be used in ultra-dry, vacuum applications, or where electrical insulation is desired.&&

About

Rulon® 123 is a glossy black non-abrasive compound for softer mating surfaces, such as stainless steel. This material has excellent chemical resistance and is FDA and USDA compliant. It is less expensive than Rulon J, but is slightly less flexible and higher in wear. It has a high resistance to deformation, low coefficient of friction and good thermal and electrostatic dissipation. This material has a maximum operating temperature of 550°F (300°C). Rulon 123 releases black wear debris over time and should not be used in ultra-dry, vacuum applications, or where electrical insulation is desired.&&

Product Description
Supplier	Saint Gobain
Generic	PTFE
Material Status	Commercial: Active
Features	Good surface appearance,Low coefficient of friction,High Heat Resistance,Non-abrasive ,Solvent resistance
Availabilitys	Africa & Middle East ,North America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	2.10	g/cm³	ASTM D792
Water absorption rate
24hr	0.00	%	ASTM D570
saturated	0.00	%	ASTM D570

THERMAL	Nominal value	Unit	Test method
Melting temperature	327	℃	ASTM D3418
Thermal conductivity coefficient	0.663	W/m/K	JIS R2618
Linear coefficient of thermal expansion
MD	1.26E-4	1/℃	ASTM D696
TD	7.92E-5	1/℃	ASTM D696
Maximum operating temperature	315	℃
Minimum service temperature	-268	℃

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch
23℃	320	J/m	ASTM D256
Limiting pressure and speed	0.350	MPa-m/s

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	60		ASTM D2240
tensile strength
23℃	17.2	MPa	ASTM D638
Tensile strain
Fracture, 23 ℃	150	%	ASTM D638
friction coefficient
compressive strength	6.89	MPa	ASTM D-882
static state	0.10-0.30

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.