KYDEX® 5555 MB

About
Microban® technology KYDEX® is specifically formulated to meet the safety needs of the aviation industry. KYDEX® 5555 is a proprietary, high performance acrylic/PVC thermoplastic sheet that meets all fire retardancy requirements set forth in Federal Aviation Regulations 25.853 paragraphs (a) and (d) (old (c)) including low heat release (65/65) in the OSU rate of heat release test. KYDEX® 5555 exceeds the heat release to a level of 55/55. Its excellent properties make it the ideal material to form two-and-three-dimensional aircraft components.&&

About

Microban® technology KYDEX® is specifically formulated to meet the safety needs of the aviation industry. KYDEX® 5555 is a proprietary, high performance acrylic/PVC thermoplastic sheet that meets all fire retardancy requirements set forth in Federal Aviation Regulations 25.853 paragraphs (a) and (d) (old (c)) including low heat release (65/65) in the OSU rate of heat release test. KYDEX® 5555 exceeds the heat release to a level of 55/55. Its excellent properties make it the ideal material to form two-and-three-dimensional aircraft components.&&

Product Description
Supplier	Sekisui
Generic	PMMA+PVC
Material Status	Commercial: Active
Features	Clean,Antimicrobial properties,Flame Characteristics,Solvent resistance
Availabilitys	North America,Latin America,Asia Pacific,Europe
Process Methods	Thermo forming

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.52	g/cm³	ASTM D792

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, annealed, 3.18 mm	75.9	℃	ASTM D648

FLAME CHARACTERISTICS	Nominal value	Test method
Flame retardant level
Radiation plate,>711.0 µ m	Pass	ASTM E162
Heat release rate	<55/55	FAR 25.853(d
Smoke generation	< 150	FAR 25.853(d

Supplementary information	Nominal value	Unit	Test method
Temperature of hot forming mold	170 to 200	℃

MECHANICAL	Nominal value	Unit	Test method
Rockwell hardness
R-grade, 3.18 mm	111		ASTM D785
tensile strength
3.18 mm	43.0	MPa	ASTM D638
Bending modulus
3.18 mm	3830	MPa	ASTM D790
bending strength
3.18 mm	81.2	MPa	ASTM D790

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.