HYDEL® PEI-7 - SOLIAO

About
In recent years, industry has demanded a range of materials that not only possess strength, wear properties, heat and chemical resistance but materials that are less resistive to the build-up of a static charge. Ensinger has a family of such materials; their properties are listed on the reverse side of this sheet and described below. A static dissipative polyetherimide utilizing proprietary filler technology which renders this material electrically conductive. This technology allows for good dimensional stability after machining (unlike conventional carbon fibers), consistent electrical properties, excellent surface quality and minimal sloughing. It also possesses outstanding toughness and excellent thermal stability.&&

About

In recent years, industry has demanded a range of materials that not only possess strength, wear properties, heat and chemical resistance but materials that are less resistive to the build-up of a static charge. Ensinger has a family of such materials; their properties are listed on the reverse side of this sheet and described below. A static dissipative polyetherimide utilizing proprietary filler technology which renders this material electrically conductive. This technology allows for good dimensional stability after machining (unlike conventional carbon fibers), consistent electrical properties, excellent surface quality and minimal sloughing. It also possesses outstanding toughness and excellent thermal stability.&&

Product Description
Supplier	Ensinger
Generic	Polyetherimide
Material Status	Commercial: Active
Features	Good Rigidity,Good flexibility,Good surface appearance,Good Dimensional Stability,Conductive,High Heat Resistance,Good wear resistance,Solvent resistance,Heat Stabilized,V-0
Availabilitys	North America

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.33	g/cm³	ASTM D792
Water absorption rate
balance	0.25	%	ASTM D570

MECHANICAL	Nominal value	Unit	Test method
Tensile modulus	2760	MPa	ASTM D638
tensile strength
yield	64.8	MPa	ASTM D638
Tensile strain
yield	4.0	%	ASTM D638
Bending modulus	2760	MPa	ASTM D790
bending strength	112	MPa	ASTM D790
compressive strength	112	MPa	ASTM D695

IMPACT	Nominal value	Unit	Test method
Notched impact strength of cantilever beam	75	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Continuous use temperature	171	℃
Linear coefficient of thermal expansion
MD	5.2E-5	1/℃	ASTM D696
Hot deformation temperature	199	℃	ASTM D648

Electrical performance	Nominal value	Unit	Test method
Surface resistivity	1.0E+6 to 1.0E+9	ohms	ASTM D257

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
Flame retardant level	V-0		UL 94

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.