EBANTIX® PA-1770

About
EBA ALCUDIA® PA-1770 is a copolymer suitable for general extrusion, injection moulding and compounds where good processability, flexibility and very good mechanical properties are required. The butyl acrylate content is 17%. It contains antioxidant additives. TYPICAL APPLICATIONS Extrusion (profiles, sheets) Injection moulding Microcellular foams Compounds and masterbatches Cables Recommended melt temperature 180°C. EBA copolymers exhibit excellent thermal stability, which allows higher processing temperatures if needed. Processing characteristics of PA-1770 are similar to LDPE and conventional polyethylene extruders are recommended. Processing conditions should be optimised for each production line.&&

About

EBA ALCUDIA® PA-1770 is a copolymer suitable for general extrusion, injection moulding and compounds where good processability, flexibility and very good mechanical properties are required. The butyl acrylate content is 17%. It contains antioxidant additives. TYPICAL APPLICATIONS Extrusion (profiles, sheets) Injection moulding Microcellular foams Compounds and masterbatches Cables Recommended melt temperature 180°C. EBA copolymers exhibit excellent thermal stability, which allows higher processing temperatures if needed. Processing characteristics of PA-1770 are similar to LDPE and conventional polyethylene extruders are recommended. Processing conditions should be optimised for each production line.&&

Product Description
Supplier	REPSOL
Generic	EBA
Material Status	Commercial: Active
Features	Excellent Processability,Good flexibility,Food contact compliance,Inoxidizability
Availabilitys	North America,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.924	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	7.0	g/10min	ISO 1133
Butyl acrylate composition	17.0	wt%

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	61.0	℃	ISO 306/A
Melting temperature	93.0	℃

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s A	90
Shaw’s D	33
tensile strength
fracture	12.0	MPa	ISO 527-2
Tensile strain
fracture	800	%	ISO 527-2

Process Conditions
injection	Nominal value	Unit	Test method
Extrusion	Nominal value	Unit	Test method
Processing (melt) temperature	180	°C
Melt temperature	180	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.