ALCUDIA® HDPE 5703-A

About
The high density polyethylene ALCUDIA® 5703A is a homopolymer of medium molecular weight specially intended for extrusion of mono and doubled wall corrugated drainage and sewage pipes. This product is supplied in natural colour but they can be easily coloured with pigments steady at processing temperature, using dry-colouring or masterbatch techniques. The ALCUDIA® 5703A has an excellent balance between rigidity and others properties as the impact strength. TYPICAL APPLICATIONS Structured doubled wall without pressure pipes for underground drainage and sewage. Mono and doubled wall corrugated pipes for protecting cables. Recommended melt temperature range 190 – 210°C. Processing conditions should be optimised for each production line.&&

About

The high density polyethylene ALCUDIA® 5703A is a homopolymer of medium molecular weight specially intended for extrusion of mono and doubled wall corrugated drainage and sewage pipes. This product is supplied in natural colour but they can be easily coloured with pigments steady at processing temperature, using dry-colouring or masterbatch techniques. The ALCUDIA® 5703A has an excellent balance between rigidity and others properties as the impact strength. TYPICAL APPLICATIONS Structured doubled wall without pressure pipes for underground drainage and sewage. Mono and doubled wall corrugated pipes for protecting cables. Recommended melt temperature range 190 – 210°C. Processing conditions should be optimised for each production line.&&

Product Description
Supplier	REPSOL
Generic	MMW-HDPE
Material Status	Commercial: Active
Features	Food contact compliance,Homopolymer,Good coloring
Availabilitys	North America,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.958	g/cm³	ISO 1183
Melt Flow Rate			ISO 1133
190℃，2.16kg	0.32	g/10min	ISO 1133
190℃，5.0kg	1.5	g/10min	ISO 1133
ESCR(Environmental Stress Cracking Resistance)
10% non-ionic detergent, F50	> 15.0	hr	ASTM D1693

MECHANICAL	Nominal value	Unit	Test method
tensile strength
fracture	30.0	MPa	EN 638
Tensile strain
fracture	> 700	%	EN 638
Bending modulus	1550	MPa	ISO 178

THERMAL	Nominal value	Unit	Test method
Embrittlement temperature	< -70.0	℃	ASTM D746

Process Conditions
Extrusion	Nominal value	Unit	Test method
Melt temperature	190 to 210	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.