| About |
|---|
| Greene, Tweed’s Arlon® 1000, a tough, hig temperature, semi-crystalline thermoplastic, offers a unique combination of mechanical, thermal and chemical propertier. Arlon 1000 features superior compressive strength and minimum creep, as well as broad chemical resistance. Arlon is an excellent choice for applications such as valve seats and bushings greater abrasion resistance and lower wear and better fatigue properties than other thermoplastics.&& |
| Product Description | |
|---|---|
| Material Status | Commercial: Active |
| Features | Fatigue resistance,Acidproof,Gamma radiation,Low extract,Good wear resistance,Good flexibility,Good compressive strength,Food contact compliance,Hypocrystalline,Alkali resistant,Solvent resistance |
| Availabilitys | North America,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.30 | g/cm³ | ASTM D792 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 177 | ℃ | ASTM D648 |
| Linear coefficient of thermal expansion | |||
| MD | ASTM E228 | ||
| < 149℃ | 4.7E-5 | cm/cm/℃ | ASTM E228 |
| > 149℃ | 1.4E-4 | cm/cm/℃ | ASTM E228 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 88 | ASTM D2240 | |
| Rockwell hardness | |||
| M-level | 104 | ASTM D785 | |
| Tensile modulus | |||
| 4240 | MPa | ASTM D638 | |
| tensile strength | ASTM D638 | ||
| yield | 108 | MPa | ASTM D638 |
| fracture | 96.5 | MPa | ASTM D638 |
| Tensile strain | |||
| fracture | 35 | % | ASTM D638 |
| Bending modulus | |||
| 0.5% secant | 4140 | MPa | ASTM D790 |
| bending strength | 174 | MPa | ASTM D790 |
| compressive strength | 131 | MPa | ASTM D695 |
| shear strength | ASTM D732 | ||
| — | 85.5 | MPa | ASTM D732 |
| friction coefficient | |||
| With oneself – dynamic | 0.29 | ASTM G77 | |
| Load deformation | 0.0900 | % | ASTM D621 |
| Wear factor | 100 | 10^-8 mm³/N·m | ASTM G77 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Break |
| 3. Transverse |
| 4. Axial |
| 5. PV + 12600 psi-ft/in |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |