| About |
|---|
| Daikin- Polyflon™ M-18 is a polytetrafluoroethylene virgin granular fine cut resin. This general purpose molding powder has been specifically designed for use in medium to large rod and billet compression molding applications.&& |
| Product Description | |
|---|---|
| Supplier | Daikin Fluorochemicals |
| Generic | PTFE |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 2.15 to 2.16 | g/cm³ | ASTM D4894 |
| Apparent density | 0.49 | g/cm³ | ASTM D4894 |
| Shrinkage rate | |||
| MD | 2.6 to 3.6 | % | Internal Method |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | 40.0 to 60.0 | MPa | JIS K6891 |
| Tensile strain | |||
| fracture | 300 to 450 | % | JIS K6891 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Dielectric strength | 110 | kV/mm | ASTM D149 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |