| About |
|---|
| Hostaform® MT12R01 is a low melt viscosity and improved slip grade for fast cycling, thin walled injection molding. Hostaform® MT12R01is a special grade developed for medical industry applications and complies with: CFR 21 (177.2470) of the Food and Drug Administration (FDA) and is listed in the Drug Master File (DMF 11559) and the Device Master File (MAF 1079) the corresponding EU and national registry regulatory requirements biocompatibility in tests corresponding to USP <88> Class VI/ISO 10993 low residual monomers no animal-derived constituents&& |
| Product Description | |
|---|---|
| Supplier | Celanese |
| Generic | Copolymer Polyformaldehyde |
| Material Status | Commercial: Active |
| Features | Low Viscosity,Quick molding cycle,ADCF,HB |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.41 | g/cm³ | ASTM D792 |
| Water absorption rate | ASTM D570 | ||
| saturated | 0.50 | % | |
| Balance, 50% RH | < 0.30 | % | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 2100 | MPa | ASTM D638 |
| tensile strength | |||
| yield | 55.0 | MPa | ASTM D638 |
| Tensile strain | |||
| yield | 30 | % | ISO 527-2 |
| Creep fracture strength | |||
| after 1000 hr. | 40 | MPa |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Hot deformation temperature | |||
| 1.8 MPa, unannealed | 110 | ℃ | ASTM D648 |
| Glass transition temperature | -60.0 | ℃ | |
| Melting peak temperature | 160 | ℃ | ASTM D3418 |
| Linear coefficient of thermal expansion | |||
| MD：23~55℃ | 9.9E-5 | 1/℃ | ASTM E831 |
| Operating temperature | |||
| long-term | 100 | ℃ |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | 1.0E+14 | ohms | IEC 60093 |
| Volume resistivity | 1.0E+14 | ohms·cm | IEC 60093 |
| Dielectric constant | |||
| 100 kHz | 3.50 | IEC 250 | |
| Dissipation factor | 3.0E-3 | IEC 250 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | HB | UL 94 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 30s |
| 3. 10°C/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |