InnoPlus HD3500C

About

Product Description
Generic	HDPE
Material Status	Commercial: Active
Features	Excellent Processability,Food contact compliance,High density,Bimodal molecular weight distribution,Heat Stabilized,High ESCR
Availabilitys	Asia Pacific

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.956	g/cm³	ASTM D1505
Melt Flow Rate
190℃，2.16kg	1.0	g/10min	ASTM D1238
ESCR(Environmental Stress Cracking Resistance)
10% non-ionic detergent, F50	460	hr	ASTM D1693B

IMPACT	Nominal value	Unit	Test method
Impact strength of cantilever beam notch	59	J/m	ASTM D256

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	120	℃	ASTM D1525 3
Melting peak temperature	130	℃	ASTM D3418

Supplementary information	Nominal value	Unit	Test method
Compression molding temperature	160 to 185	℃

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	62		ASTM D2240
tensile strength
yield	23.5	MPa
fracture	26.5	MPa
Tensile strain
fracture	910	%	ASTM D638
Bending modulus
23℃	794	MPa	ASTM D747
Bending modulus	902	MPa	ASTM D790

Process Conditions
Injection	Nominal value	Unit	Test method
Processing (melt) temperature	180 to 210	°C

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.