| About |
|---|
| ALFATER XL® A80I 4FC0010 is a Polypropylene + EPDM Rubber (PP+EPDM) product. It can be processed by injection molding and is available in Asia Pacific, Europe, or North America. Applications of ALFATER XL® A80I 4FC0010 include caps/lids/closures, electrical/electronic applications, handles, household applications and packaging. Characteristics include: RoHS Compliant Food Contact Acceptable High Flow Weather Resistant&& |
| Product Description | |
|---|---|
| Supplier | ALBIS |
| Generic | PP+EPDM |
| Material Status | Commercial: Active |
| Features | Weather resistance is good,Alkali resistant,High liquidity,Hydrolysis stability,Food contact compliance,Ozone resistance |
| Availabilitys | North America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.930 | g/cm³ | ISO 1183 |
| Shrinkage rate | |||
| TD：24 hrs | 0.90 to 1.3 | % | |
| MD：24 hrs | 1.1 to 1.5 | % | |
| Spiral flow length | |||
| 2.00 mm | 70.0 | n | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shore A, 15 seconds | 80 | ISO 7619 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 6.30 | MPa | ISO 37 |
| 100% strain | 3.50 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 500 | % | ISO 37 |
| tear strength | 38 | kN/m | ISO 34-1 |
| Compression deformation | |||
| 22℃，72 hr | 38 | % | |
| 70℃，22 hr | 54 | % | |
| 100℃，22 hr | 60 | % | |
| 125℃，72 hr | 80 | % |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Operating temperature | -40 to 125 | ℃ |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Drying temperature – hot air dryer | 70 to 80 | °C | |
| Drying time – hot air dryer | 2.0 to 4.0 | hr | |
| Processing (melt) temperature | 195 to 215 | °C | |
| Mold temperature | 10 to 70 | °C | |
| Injection speed | 快速 | ||
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Type 2 |
| 3. Method Ba, Angle (Unnicked) |
| 4. Type A |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |