Sumikon® FM-MK-120E

About
SUMIKON® FM-MK-120E is Glass fiber and inorganic filler filled Polyphenylene sulfide molding compound with good mechanical property grade. This grade is official registered UL with V-0 (t=1.6).&&

Product Description
Supplier	SBHPP
Generic	PPS
Material Status	Commercial: Active
Features	V-0
Availabilitys	Asia Pacific
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	1.87	g/cm³	ASTM D792
Shrinkage rate			Internal Method
MD	0.20	%	Internal Method
TD	0.40	%	Internal Method

MECHANICAL	Nominal value	Unit	Test method
tensile strength	95.0	MPa	ASTM D638
Bending modulus	16000	MPa	ASTM D790
bending strength	158	MPa	ASTM D790

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	> 260	℃	ASTM D648
Linear coefficient of thermal expansion			TMA
MD	20	ppm	TMA
TD	26	ppm	TMA

FLAME CHARACTERISTICS	Nominal value	Unit	Test method
1.60 mm	V-0		UL 94

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.