| About |
|---|
| SynPrime™ Trimellitate Esters are API category Group V fluids. These aromatic esters are designed for high temperature applications which require relatively high viscosity, excellent oxidative stability, good solvency, and good lubricating properties. SynPrime™ Trimellitate Esters can be used either as sole synthetic basefluids or additives in automotive and industrial lubricant applications such as engine oils, compressor oils, high-temperature chain oils, and greases.&& |
| Product Description | |
|---|---|
| Supplier | Polyone |
| Generic | 润滑剂 |
| Material Status | Commercial: Active |
| Availabilitys | North America,Latin America,Asia Pacific,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.967 to 0.973 | g/cm³ | ASTM D4052 |
| Viscosity Index | 122 | ASTM D2270 | |
| water content | < 1000 | ppm | ASTM D6304 |
| acid value | < 0.10 | mg KOH/g | ASTM D974 |
| exterior | 清洁，干净 | ASTM D2090 | |
| colour | < 100 | ASTM D1209 | |
| Viscosity – Kinematic | |||
| 40℃ | 52.9 | cSt | |
| 100℃ | 8.08 | cSt | |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Casting point | -54 | ℃ | ASTM D97 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Ignition point | 322 | ℃ | ASTM D92 |
| flash point | 296 | ℃ | ASTM D92 |
| optical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Refractive index | |||
| 25℃ | 1.4813 | ASTM D1218 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 25/25°C |
| 3. Pt-Co Scale, Maximum |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |