Purell PE 3220 D

About
Purell PE 3220 D is a low density polyethylene with high rigidity and good chemical resistance. It is delivered in pellet form. The grade is used by our customers for packaging of pharmaceuticals in the small blow moulding market such as in blow fill seal technology. Without exception, all potential activities for applications in the pharmaceutical, medical device, laboratory and diagnostics area have to be discussed with the relevant LyondellBasell Technical and Business contacts first.&&

About

Purell PE 3220 D is a low density polyethylene with high rigidity and good chemical resistance. It is delivered in pellet form. The grade is used by our customers for packaging of pharmaceuticals in the small blow moulding market such as in blow fill seal technology. Without exception, all potential activities for applications in the pharmaceutical, medical device, laboratory and diagnostics area have to be discussed with the relevant LyondellBasell Technical and Business contacts first.&&

Product Description
Supplier	LyondellBasell
Generic	LDPE
Material Status	Commercial: Active
Features	Good Rigidity,Low density,Solvent resistance,Ethylene oxide disinfection
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.930	g/cm³	ASTM D1505
Density	0.930	g/cm³	ISO 1183
Apparent density	> 0.50	g/cm³	ISO 60
Melt Flow Rate
190℃，2.16kg	0.40	g/10min	ASTM D1238
190℃，2.16kg	0.40	g/10min	ISO 1133

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	54		ISO 868
Tensile modulus	430	MPa	ISO 527-2
1% cut, molded	483	MPa	ASTM D638
tensile strength
fracture	13.8	MPa	ASTM D638
yield	13.0	MPa	ISO 527-2
yield	16.5	MPa	ASTM D638
Tensile strain
fracture	660	%	ASTM D638
yield	12	%	ISO 527-2
Bending modulus
1% secant	494	MPa	ASTM D790

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	48.0	℃	ASTM D648
Vicat Softening Temp	107	℃	ASTM D1525
A50	110	℃	ISO 306/A50
Melting temperature
DSC	117	℃	ISO 3146

Process Conditions
injection	Nominal value	Unit	Test method
Extrusion	Nominal value	Unit	Test method
Processing (melt) temperature	170 to 220	°C
Melt temperature	170 to 220	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.