| About |
|---|
| HD T10 is a HDPE yarn/monofilament grade produced by Spherilene Technology. This grade can be used in yarns/monofilament for Fabrics, Nets, Twines & Ropes. HD T10 is characterized by excellent processability and mechanical strength.&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Good Rigidity,Excellent Processability |
| Availabilitys | Asia Pacific |
| Process Methods | Extrusion |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.950 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 1.1 | g/10min | ASTM D1238 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23℃ | 500 | J/m | ASTM D256 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting peak temperature | 131 | ℃ | ASTM D3418 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| Shaw’s D | 61 | ASTM D2240 | |
| tensile strength | ASTM D638 | ||
| Yield, molding | 26.0 | MPa | ASTM D638 |
| Fracture, molded | 38.0 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, molded | > 1000 | % | ASTM D638 |
| Bending modulus | 1000 | MPa | ASTM D790 |
| Process Conditions | |||
|---|---|---|---|
| Extrusion | Nominal value | Unit | Test method |
| Barrel 1 zone temperature | 200 to 240 | °C | |
| Barrel 2 zone temperature | 200 to 240 | °C | |
| Barrel 3 zone temperature | 200 to 240 | °C | |
| Barrel 4 zone temperature | 200 to 240 | °C | |
| Barrel 5 zone temperature | 200 to 240 | °C | |
| Nozzle temperature | 230 to 250 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 23°C |
| 3. Type IV |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |