| About |
|---|
| APICAL 50NP is a PI Film material. It is available in Latin America or North America.&& |
| Product Description | |
|---|---|
| Supplier | Kaneka |
| Generic | PI |
| Material Status | Commercial: Active |
| Features | Low coefficient of friction |
| Availabilitys | North America,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Water absorption rate | |||
| 23℃，24hr | < 3.8 | % | IPC TM-650 2.6.2 |
| film | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | ASTM D882A | ||
| MD, fracture | > 207 | MPa | ASTM D882A |
| TD, fracture | > 207 | MPa | ASTM D882A |
| Tensile strain | ASTM D882A | ||
| MD, fracture | > 40 | % | ASTM D882A |
| TD, fracture | > 40 | % | ASTM D882A |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | |||
| 200 ℃ | > 1.0E+12 | ohms·cm | ASTM D257 |
| Dielectric strength | |||
| In the air | > 240 | kV/mm | ASTM D149 |
| Dielectric constant | |||
| 1 kHz | < 3.90 | ASTM D150 | |
| Dissipation factor | |||
| 1 kHz | < 3.5E-3 | ASTM D150 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 500 V/sec |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |