Bormed™ HE9621-PH

About
Bormed HE9621-PH is a resin intended for evaluation for use in Healthcare applications. Bormed HE9621-PH is a high density polyethylene with narrow molecular weight distribution typically used in injection moulding of articles requiring medium flow with high rigidity. This grade is designed for articles which require high stiffness and low warpage. Material can be sterilised with ethylene oxide, steam and radiation up to 35 kGy; as a result of sterilisation by radiation some minor yellowing can occur.&&

About

Bormed HE9621-PH is a resin intended for evaluation for use in Healthcare applications. Bormed HE9621-PH is a high density polyethylene with narrow molecular weight distribution typically used in injection moulding of articles requiring medium flow with high rigidity. This grade is designed for articles which require high stiffness and low warpage. Material can be sterilised with ethylene oxide, steam and radiation up to 35 kGy; as a result of sterilisation by radiation some minor yellowing can occur.&&

Product Description
Supplier	Borealis AG
Generic	HDPE
Material Status	Commercial: Active
Features	Good Rigidity,Low warping,Steam sterilized,Renewable resources,Weight distribution,Radiation disinfection,Moderate liquidity,Ethylene oxide disinfection
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe
Process Methods	Injection Molding

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.962	g/cm³	ISO 1183
Melt Flow Rate
190℃，2.16kg	12	g/10min	ISO 1133
Shrinkage rate	1.0 to 2.0	%

MECHANICAL	Nominal value	Unit	Test method
Shore hardness
Shaw’s D	62		ISO 868
Tensile modulus
injection molding	1150	MPa	ISO 527-1-2
tensile strength
Yield, injection molding	26.0	MPa	ISO 527-2/50
Tensile strain
Yield, injection molding	9.0	%	ISO 527-2/50
Bending modulus	1300	MPa	ISO 178

IMPACT	Nominal value	Unit	Test method
Charpy Notched Impact Strength	4.0	kJ/m²	ISO 179-1eA

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
0.45 MPa, unannealed	73.0	℃	ISO 75-2/B

Process Conditions
injection	Nominal value	Unit	Test method
Processing (melt) temperature	200 to 260	°C
Mold temperature	10 to 40	°C
Injection speed	Fast

Notes
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.