Vipel® F007-AAA-00

About
AOC’s Vipel F007 is a low VOC, bisphenol A, epoxy-based vinyl ester resin dissolved in styrene. BENEFITS Versatile The Vipel F007 Series is ideally suited for use in hand lay-up, spray-up, filament winding and pultrusion processes where outstanding mechanical properties and excellent resistance to chemicals and heat are required. Wide formulating capabilities allow for use in many processes and for optimization of cost/performance. Corrosion Resistant Refer to AOC’s “Corrosion Resistant Resin Guide under product F007” for corrosion resistance information. For questions regarding suitability of a resin to any particular chemical environment, contact AOC.&&

About

AOC’s Vipel F007 is a low VOC, bisphenol A, epoxy-based vinyl ester resin dissolved in styrene. BENEFITS Versatile The Vipel F007 Series is ideally suited for use in hand lay-up, spray-up, filament winding and pultrusion processes where outstanding mechanical properties and excellent resistance to chemicals and heat are required. Wide formulating capabilities allow for use in many processes and for optimization of cost/performance. Corrosion Resistant Refer to AOC’s “Corrosion Resistant Resin Guide under product F007” for corrosion resistance information. For questions regarding suitability of a resin to any particular chemical environment, contact AOC.&&

Product Description
Generic	乙烯基酯
Material Status	Commercial: Active
Features	Corrosion Resistant,High Heat Resistance,Low odor,Solvent resistance
Availabilitys	Africa & Middle East ,North America,Latin America,Asia Pacific,Europe

Technical Data
PHYSICAL	Nominal value	Unit	Test method
styrene content	32	%

THERMAL	Nominal value	Unit	Test method
Hot deformation temperature
1.8 MPa, unannealed	130	℃	ASTM D648

Supplementary information	Nominal value	Unit	Test method
Gel to Peak	7.0	min
exothermic peak	188	℃

Uncured Properties	Nominal value	Unit
Density	1.07	g/cm³
viscosity
25℃，Brookfield RVT	0.40	Pa·s
Gelation time
25℃	25	min

MECHANICAL	Nominal value	Unit	Test method
Babbitt hardness	44		ASTM D2583
Tensile modulus	3590	MPa	ASTM D638
tensile strength	95.1	MPa	ASTM D638
Tensile strain
fracture	5.1	%	ASTM D638
Bending modulus	3860	MPa	ASTM D790
bending strength	163	MPa	ASTM D790

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.