| About |
|---|
| Description : Impact modified, tin stabilised, extrusion blow moulding bottle grade Application : Extrusions blow moulded bottles and injection moulding components Specification : Complies with EEC directive 90/128/EEC for plastics in contact with foodstuffs VCM Content, EEC- 81/432CEE: <1 ppm&& |
| Product Description | |
|---|---|
| Supplier | INEOS |
| Generic | PVC, not specified |
| Material Status | Commercial: Active |
| Features | High impact resistance,Food contact compliance,Good stability |
| Availabilitys | Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.34 | g/cm³ | BS 2782 620A |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Vicat Softening Temp | 74.0 | ℃ | BS 2782 120B |
| Linear coefficient of thermal expansion | |||
| MD | 6.0E-5 | 1/℃ | ASTM D696 |
| Thermal conductivity coefficient | |||
| 23℃ | 0.16 | W/m/K | ASTM C177 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Surface resistivity | 1.0E+13 | ohms | BS 2782 |
| Volume resistivity | 5.0E+14 | ohms·cm | BS 2782 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Rockwell hardness | |||
| R-level | 115 | ASTM D785 | |
| Tensile modulus | |||
| 1% secant, 23 ℃ | 2500 | MPa | ASTM D638 |
| tensile strength | |||
| yield | 40.0 | MPa | BS 2782 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |