Supreme™ 081

About
Supreme™ 081, Polyolefin Plastomer (POP), is an ethylene-octene copolymer produced via Nexlene™ technology. Supreme™ 081 performs well in a wide range of various food & non-food packaging films with excellent sealing property and impact strength. Typical Performance: Excellent low seal initiation temperature and hot tack strength Superior impact strength and transparency Compiles with: US. FDA 21 CFR 177.1520 EU. No 10/2011&&

About

Supreme™ 081, Polyolefin Plastomer (POP), is an ethylene-octene copolymer produced via Nexlene™ technology. Supreme™ 081 performs well in a wide range of various food & non-food packaging films with excellent sealing property and impact strength. Typical Performance: Excellent low seal initiation temperature and hot tack strength Superior impact strength and transparency Compiles with: US. FDA 21 CFR 177.1520 EU. No 10/2011&&

Product Description
Supplier	SKC
Generic	POP
Material Status	Commercial: Active
Features	Good Clarity,Good heat sealing,High impact resistance,Food contact compliance,Octene copolymer,Copolymer
Availabilitys	North America,Asia Pacific,Europe
Process Methods	Film extrusion

Technical Data
PHYSICAL	Nominal value	Unit	Test method
Density	0.908	g/cm³	ASTM D792
Melt Flow Rate
190℃，2.16kg	1.0	g/10min	ASTM D1238

film	Nominal value	Unit	Test method
film thickness
test	40	µm	ASTM D374
Secant modulus
1% secant, MD: 40 µ m	95.1	MPa
1% secant, TD: 40 µ m	106	MPa
tensile strength
MD, fracture, 40 µ m	47.1	MPa
TD, fracture, 40 µ m	52.0	MPa
Tensile strain
MD, fracture, 40 µ m	560	%
TD, fracture, 40 µ m	640	%
Drop hammer impact
40 µm	> 1000	g	ASTM D1709-A
Elmandorf tear strength
MD：40 µm	13	g
TD：40 µm	20	g

THERMAL	Nominal value	Unit	Test method
Vicat Softening Temp	96.0	℃	ASTM D1525
Melting temperature	105	℃	Internal Method

optical performance	Nominal value	Unit	Test method
Haze	6.0	%	ASTM D1003

Supplementary information	Nominal value	Unit	Test method
Sealing Initial Temperature	96	℃	Internal Method

Process Conditions
Squeeze description	Nominal value	Unit	Test method
Extrusion	Nominal value	Unit	Test method

Melt temperature	160 to 180	°C

Notes
1. Typical properties: these are not to be construed as specifications.
【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.

Notes

1. Typical properties: these are not to be construed as specifications.

【 Disclaimer 】
Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials.