| About |
|---|
| Product Description | |
|---|---|
| Supplier | DSM |
| Generic | PA66 |
| Material Status | Commercial: Active |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 1.360 | g/cm³ | ISO 1183 |
| Water absorption rate | |||
| 0.6 | % | ISO 62 | |
| 1.6 | % | ISO 62 | |
| Shrinkage rate | |||
| 0.2 | % | ISO 294-4 | |
| 1.2 | % | ISO 294-4 | |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile modulus | 9500 | MPa | ISO 527-1/-2 |
| tensile strength | |||
| fracture | 190 | MPa | ISO 527-1/-2 |
| Tensile strain | |||
| fracture | 3 | % | ISO 527-1/-2 |
| Bending modulus | 8400 | MPa | ISO 178 |
| bending strength | 250 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Unnotch Impact strength | |||
| -30℃ | 10 | kJ/m² | ISO 179/1eU |
| 23℃ | 12 | kJ/m² | ISO 179/1eU |
| Charpy Notched Impact Strength | |||
| -30℃ | 70 | kJ/m² | ISO 179/1eA |
| 23℃ | 80 | kJ/m² | ISO 179/1eA |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Melting temperature | |||
| 10°C/min | 260 | ℃ | ISO 11357-1/-3 |
| Hot deformation temperature | |||
| 1.80 MPa | 245 | ℃ | ISO 75-1/-2 |
| 0.45 MPa | 260 | ℃ | ISO 75-1/-2 |
| Linear coefficient of thermal expansion | |||
| MD | 0.2 | E-4/℃ | ISO 11359-1/-2 |
| TD | 0.7 | E-4/℃ | ISO 11359-1/-2 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| Flame retardant level | |||
| 1.5mm | HB | IEC 60695-11-10 |
| Notes |
|---|
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |