| About |
|---|
| Characteristics: Homopolymer polypropylene with stable processability and high cleanness, lot to lot uniformity, excellent gauge control, easy stretching and orientation. Recommended for: High speed BOPP lines, it is suitable for metallizable film, films that require excellent transparency and gloss, extrusion and injection molding general purpose applications.&& |
| Product Description | |
|---|---|
| Generic | PP homopolymerization |
| Material Status | Commercial: Active |
| Features | Excellent Processability,High purity,Good surface appearance,Good Gauge Control,Food contact compliance,Good Tensile Strength,Electroplating,Homopolymer |
| Availabilitys | Africa & Middle East ,North America,Latin America,Asia Pacific,Europe |
| Process Methods | Injection Molding |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Melt Flow Rate | |||
| 230℃，2.16kg | 3.2 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, 3.20 mm, injection molding | 33.8 | MPa | ASTM D638 |
| Tensile strain | |||
| Yield, 3.20 mm, injection molding | 11 | % | ASTM D638 |
| Bending modulus | |||
| 1% cut, 3.20 mm, injection molded | 1410 | MPa | ASTM D790-A |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Impact strength of cantilever beam notch | |||
| 23 ℃, 3.2mm, injection molding | 32 | J/m | ASTM D256-A |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. Procedure B |
| 3. Type I, 2.0 in/min |
| 4. Type I, 0.051 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |