| About |
|---|
| Designed for compounding & masterbatch&& |
| Product Description | |
|---|---|
| Generic | Linear low density polyethylene |
| Material Status | Commercial: Active |
| Features | Low density |
| Availabilitys | Africa & Middle East ,Europe |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.926 | g/cm³ | ISO 1872-1 |
| Apparent density | 0.42 to 0.50 | g/cm³ | ASTM D1895 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 50 | g/10min | ISO 1133 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 23℃，F50 | > 60.0 | hr | ASTM D1693 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| yield | 16.0 | MPa | ISO 527-1-2 |
| Tensile strain | |||
| fracture | 100 | % | ISO 527-2/1 |
| Bending modulus | 280 | MPa | ISO 178 |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Charpy Unnotch Impact strength | 43 | kJ/m² | ISO 179 |
| Electrical performance | Nominal value | Unit | Test method |
|---|---|---|---|
| Volume resistivity | 7.0E+15 | ohms·cm | ASTM D257 |
| Dielectric strength | 60 | kV/mm | ASTM D149 |
| Dielectric constant | 2.15 | ASTM D150 | |
| Dissipation factor | 1.0E-3 | ASTM D150 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |