| About |
|---|
| Cerberon™ 2110-65 is a Thermoplastic Vulcanizate Alloy (TPV Alloy) material. It is available in North America.&& |
| Product Description | |
|---|---|
| Generic | 其他TPV合金 |
| Material Status | Commercial: Active |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.968 | g/cm³ | ISO 1183 |
| Melt Flow Rate | |||
| 200℃，5.0kg | 57 | g/10min | ASTM D1238 |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Shore hardness | |||
| 15 seconds | 63 | ISO 868 |
| elastic body | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| fracture | 4.50 | MPa | ISO 37 |
| Tensile strain | |||
| fracture | 520 | % | ISO 37 |
| tear strength | 20 | kN/m | ISO 34-1 |
| Compression deformation | |||
| 70℃，22 hr | 29 | % | ISO 815 |
| Aging performance | Nominal value | Unit | Test method |
|---|---|---|---|
| The rate of change in tensile strength in air | |||
| 110℃，100 hr | 29 | % | ISO 188 |
| Changes in tensile stress during fracture in air | |||
| 110℃，100 hr | 37 | % | ISO 188 |
| FLAME CHARACTERISTICS | Nominal value | Unit | Test method |
|---|---|---|---|
| atomization | |||
| Photometric，6h | 80.0 | SAE J1756 |
| Supplementary information | Nominal value | Unit | Test method |
|---|---|---|---|
| Color stability | 0.170 |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 20 in/min |
| 3. Method B, Angle, 2.0 in/min |
| 4. Method B |
| 5. 102°C heating temperature, 38°C cooling temperature |
| 6. Condition 5, Rotating Rack 1rpm, 1240.8 kJ/m^3 |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |