| About |
|---|
| HPB-0345 is a certified prime grade Phillips Process BLOW MOLDING copolymer designed to meet end-use requirements of containers for packaging of Household Industrial Chemicals (HIC). HPB-0345 features easy and consistent processability in conventional continuous or intermittent extrusion equipment. It also offers exceptional ESCR and Impact strength. Applications include containers for detergents, bleach, antifreeze, motor oil and agricultural chemicals. HPB-0345 recommended melt temperature is 180 to 200°C, with the mold at 10 to 20°C. HPB-0345 complies with FDA regulation 21CFR 177.1520(c) 3.2(a) and with most international regulations concerning the use of Polyethylene in contact with food articles.&& |
| Product Description | |
|---|---|
| Generic | HDPE |
| Material Status | Commercial: Active |
| Features | Excellent Processability,High impact resistance,Food contact compliance,Copolymer,High density,Solvent resistance,High ESCR,Resistance to detergents |
| Availabilitys | North America |
| Technical Data | |||
|---|---|---|---|
| PHYSICAL | Nominal value | Unit | Test method |
| Density | 0.945 | g/cm³ | ASTM D1505 |
| Melt Flow Rate | |||
| 190℃，2.16kg | 0.35 | g/10min | ASTM D1238 |
| ESCR(Environmental Stress Cracking Resistance) | |||
| 100% non-ionic detergent, molded, F50 | > 1000 | hr | ASTM D1693B |
| MECHANICAL | Nominal value | Unit | Test method |
|---|---|---|---|
| tensile strength | |||
| Yield, molding | 24.1 | MPa | ASTM D638 |
| Tensile strain | |||
| Fracture, molded | 900 | % | ASTM D638 |
| Bending modulus | |||
| Tangent, molded | 1040 | MPa | ASTM D790-A |
| IMPACT | Nominal value | Unit | Test method |
|---|---|---|---|
| Tensile impact strength | |||
| Compression Molding | 231 | kJ/m² | ASTM D1822 |
| THERMAL | Nominal value | Unit | Test method |
|---|---|---|---|
| Embrittlement temperature | < -75.0 | ℃ | ASTM D746 |
| Vicat Softening Temp | 121 | ℃ | ASTM D1525 |
| Process Conditions | |||
|---|---|---|---|
| injection | Nominal value | Unit | Test method |
| Extrusion | Nominal value | Unit | Test method |
| Mold temperature | 10.0 to 20.0 | °C | |
| Melt temperature | 180 to 200 | °C | |
| Notes |
|---|
| 1. Typical properties: these are not to be construed as specifications. |
| 2. 2.0 in/min |
| 3. 0.051 in/min |
| 【 Disclaimer 】 Guangzhou Soliao Information Technology Co., Ltd. reserves all rights. The information in this data table was obtained from the manufacturer of the material on soliao.com. Soliao.com makes every effort to ensure the accuracy of this data. However, the search company does not assume any responsibility for the uncertainty and consequences caused to users by these data values and suggestions, and strongly recommends verifying the data values with the material supplier before the final selection of materials. |